However, I do not know where is the value at input1 is comming from.When there is no material on the roller, it starts spinning and the speed goes up to 100%, also the value at input1 of the RFG is 100%.If I modify the textile tensioning value (rotate the poti) the speed is reduced (also the value in input1). I have to provide a switch by which the operator can change the winding direction (CW or CCW).When I connect to the drive with WinBass, I can see that this tensioning value (potmeter) is connected to input 2 of the ramp function generator RFG. The speed is controlled by the tension of the textile before the roller. Hello,I have a drive running a roller which is winding a textile material.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |